-
Remove the three right
rear and end chamber covers,
Figure 5, and check the various gears and drive shaft
coupling for shake and wear. Replace or repair as required. Put a few
drops of oil on these parts.
-
Remove the right cloth
plate and check the
lower universal joint, Figure 6,
for wear. Repair or replace as
needed. Then place a few drops of oil on the
joints.
-
Before replacing the
cloth plates put a few drops
of oil, Figure 7, on the areas
that are accessible under the cloth plate insert.
-
Replace the left and
right cloth plates,
Figure
8, and place a few drops of
oil at each hole marked "oil".
|
|